將變速桿撥至各個檔位，檢查檔位指示燈與變速桿位置是否一致，如有異常，應調節空檔起動開關螺栓和開關電路。
Turn the shift lever to each gear, check whether the gear indicator is consistent with the shift lever position. If there is any abnormality, adjust the bolt and switch circuit of the neutral start switch.
將變速桿撥至各個檔位，檢查檔位指示燈與變速桿位置是否一致、P位和N位時發動機能否起動，R位時倒檔燈是否亮起。發動機應只能在空檔（N檔）和駐車檔（P檔）起動，其他檔位不能起動，若有異常，應調節空檔起動開關螺栓和開關電路。
Turn the shift lever to each gear, check whether the gear indicator is consistent with the shift lever position, whether the engine can start at P and N positions, and whether the reverse light is on at R position. The engine can only be started in neutral (n gear) and Park (P gear), and other gears can not be started. If there is any abnormality, adjust the bolt of neutral start switch and switch circuit.
1）松開檔位開關的固定螺釘，將變速桿置于N檔位。
1) Loosen the fixing screw of the gear switch and put the shift lever in the N position.
2）將槽口對準空檔基準線。有些自動變速器的檔位開關外殼上刻有一條基準線，調整時應將基準線和手動閥搖臂軸上的槽口對齊，也有一些自動變速器的檔位開關上有一個定位孔，調整時應使搖臂上的定位孔和檔位開關上的定位孔對準。
2) Align the notch with the neutral reference line. There is a reference line engraved on the gear switch housing of some automatic transmissions. When adjusting, the reference line should be aligned with the notch on the rocker arm shaft of the manual valve. In some automatic transmissions, there is a positioning hole on the shift switch. During adjustment, the positioning hole on the rocker arm should be aligned with the positioning hole on the gear switch.
3）檔位開關的位置調好后進行固定。
3) The position of the gear switch is adjusted and fixed.
The highlights of this issue are compiled by Jinan Benz automobile maintenance editor. Thank you for your reading. If there is anything wrong, please visit our official website: m.nanofluidizer.com Leave us a comment and we will give you a satisfactory reply
